科技创新
Innovation

Unloading platform requirements

2020-06-01 16:37:19 Zhejiang Huayang Construction Co., Ltd. Read

The foundation of the floor unloading platform should be tamped or hardened in advance to meet the bearing capacity requirements. The bottom of the pole should be set with wooden pads or steel bases, and the horizontal and horizontal sweeping rods should be added. The platform should be fully covered with scissors.

The height of the floor discharge platform shall not be greater than 20m.

  The pole spacing, step distance and erection height requirements of the steel pipe fastener floor-mounted discharge platform are determined by calculation, which meets the requirements of scaffolding specifications, and it is strictly forbidden to connect with the outer frame and the formwork support frame.

There are protective railings on the side, safety warning and load limit signs. The platform board is tightly laid, leaving no gaps.

  The floor-type discharge platform should be checked and accepted after each installation and make a record.


The construction of scaffolding is usually the top priority of construction safety. Only when the construction of scaffolding is done well can we be qualified to talk about safe and civilized construction. In actual construction, accidents caused by scaffolding are not uncommon, causing

Countless casualties and property losses. Therefore, the construction safety of the scaffolding should be guaranteed from the details, and the operation should be strictly in accordance with the construction points of the scaffolding. The following scaffolding and internal support

The company's standard practice for supporting and unloading platforms should be kept in mind during the construction of each project department of Huayang Construction.


Copyright © 2019 huangyangjianshe.com All Rights Reserved.

Technical Support:Dreamsoar